Filter
Top Products
5 By Firstech, LLC By Firstech, LLC 4
Remote Reference Quick Reference
When servicing or loaning your vehicle to others, your remote start system should be placed in Valet mode. Valet mode prevents the system from
remote starting and disables all alarm functions.
IMPORTANT: While in Valet mode the remote start will still lock and unlock power lock systems.
With the CS600-A the alarm triggers will not function however the doors will still function.
The system can be put into valet one of two ways:
1.Turn the vehicles key to the ignition “on” position and tap the Lock and Trunk buttons simultaneously for a half second. The parking lights
will flash once to confirm the system is in valet mode. Repeat this process to take the system out of valet mode. Upon tapping the same buttons
again the parking lights will flash twice to confirm the system is out of valet mode.
2. You can put the system into valet by turning the ignition key “on” and then “off” five times within 7 seconds. The parking lights will flash once to confirm
the system is in valet mode. Shortly after the first flash, the parking lights will flash twice.
v@m
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the
battery.
One Button Remotes: 600R
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart being careful to not touch
the circuit board. The 600R requires one A23 battery. These specialty batteries can be purchased from your local Firstech dealer or an electronics store.
r@mMb@r
CM-600
CM-1300 (alarm only)
600R (1-Way 4Button Remote)
Applicable to the Following models: