Firstech, LLC. CS-600 Remote Starter User Manual


 
Programming Multiple Remotes: After the confirmation flash given in
STEP 2, code additional remotes by pressing the single button
on
remote. The parking lights will flash once confirming each additional
remote. The CS-600-S can store up to three remotes.
Exiting Programming: Programming is a timed sequence. If you can
not get the remote(s) to program then the system enters Valet Mode.
The parking lights will flash twice signaling the end of programming
mode.
Remote Start Error Diagnostic
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
Remote Start Error
1 Motor running
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or voltage sensing failure
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us
directly.
8