Filter
Top Products
General System Functions General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The four
button configuration allows for keyless entry, trunk release, and/or remote start functionality. These
commands may require additional parts and labor. Please check with your place of purchase for more
information.
The remote transmitter functions have been predetermined and programmed from the factory. The four
button configuration allows for keyless entry, trunk release, and/or remote start functionality. These
commands may require additional parts and labor. Please check with your place of purchase for more
information.
Sending Commands Sending Commands
When in range, and a button has been pressed, the remote bright blue LED will illuminate and vehicle’s
parking lights will flash. For example, to send a remote start command from the CS-600, hold down the
Key/Start button for 2.5 seconds. The remote bright blue LED will come on solid and then flash.
When in range, and a button has been pressed, the remote bright blue LED will illuminate and vehicle’s
parking lights will flash. For example, to send a remote start command from the CS-600, hold down the
Key/Start button for 2.5 seconds. The remote bright blue LED will come on solid and then flash.
Active Lock/Arm and Unlock/DisarmActive Lock/Arm and Unlock/Disarm
Tap the button for 0.5 second to lock/arm your vehicle. Tap the button to
unlock/disarm your vehicle. The remote bright blue LED will flash indicating the signal has been
sent to the vehicle. This feature is optional and may require additional programming and/or installation.
Please check with your place of purchase for details.
Automatic Transmission Remote Start Function
Hold the button for 2.5 seconds to remote start an automatic transmission vehicle. If you are in
range and if the vehicle is ready to remote start, the vehicle parking lights will flash once.
If you are in range, the parking lights on the vehicle will flash three times followed by a certain number
after that, there is a remote start error. Refer to the “remote start error diagnostic” on page 7 of this
manual for details.
Upon receiving confirmation that your vehicle is running, the parking lights will light solid. The remote
start run time can be set for 3, 15, 25, or 45 minutes. This should be set at the time of installation. If not
ask your place of purchase to adjust the option if you would like a run-time other than the default 15
minutes.
IMPORTANT: The vehicle’s key must be inserted into the ignition and turned to the “on” position prior to
driving your vehicle. If the foot brake is depressed prior to the key being in the “on” position, the vehicle
will shut off.
Trunk Release
Hold button for 2.5 seconds to release the trunk or hatch. If you are in range, the
vehicle’s parking lights will flash once and/or siren chirp once indicating that the trunk release
command has been successfully transmitted. IMPORTANT: Trunk release is an optional vehicle feature
that may require additional parts and labor.
Auxiliary Outputs/Rear Lift Gate/Sliding Doors
Your system has the ability to use outputs that can be configured to control power sliding doors or a rear
lift gate. These outputs some sort of data module. Your authorized Firstech dealer can set these outputs
up accordingly. Using auxiliary outputs to control additional vehicle functions will require additional parts
and can be rather labor extensive.
Tap button
for 0.5 seconds to trigger auxiliary output 1. Tap button for 0.5
6