Filter
Top Products
Lights
Headlights
Alignment
For aiming the headlights,
screw 6 (vertically) and C
(horizontally) are readily acces-
sible after removing retaining
ring G.
Removal
Turn off screw E and remove
retaining ring 6. Slacken 4
screws Dand,byturning counter-
clockwise remove headlight unit
L. Then pull off terminal socket I.
Caution: Replace blown bulbs
exclusively with bulbs of the same
type and wattage. Weaker bulbs
will diminish visibility whereas
stronger bulbs will draw a greater
amount of current and overwork
the alternator, resulting in progressi-
ve battery discharge. For bulb speci-
fications see page 63.
Installation
Center headlight unit L on body
by aligning locating dowel H with its
seat. Turn the unit clockwise and tigh-
ten screws D. Refit retaining ring G
by tightening screw E in hole F.
Front Parking and Turn Signal
Lamps
A Lens mounting screws
B Lens
C Bayonet-coupled bulb, double fila-
ment
D Positioning tabs
46