Excalibur electronic PR11BK-2 Motorized Toy Car User Manual


 
Operating your Motorized Bumper Boat
The accelerator button is located on the right hand top of the steering
wheel. The left hand top is the squirt gun. Press to activate the propeller
and make the Bumper Boat go!
Use the steering wheel to control in which direction you move. The
steering wheel can rotate 360°.
Battery Information
• Use 6 D-cell batteries
• Use alkaline batteries for best performance
• Do not use rechargeable batteries
• Do not mix old and new batteries
• Remove exhausted batteries from unit
• Remove batteries when Bumper Boat is not in use
• To avoid explosion or leakage, do not dispose of batteries in a fire or attempt to recharge standard or alkaline batteries
• Do not mix alkaline, standard ( carbon-zinc) or rechargeable (nickel-cadmium) batteries
Safety and Care
• When assembling, please make sure that you tighten the screws on the battery compartment so that water does not get
on the inside of the compartment. This will damage the electrical system of the Bumper Boat.
• Children under 8 years of age should not operate this product without parental supervision.
• This product is designed for pool use only. It may be used in ponds or small lakes only within the range of the userʼs
comfortable ability to swim to shore, provided that there are no strong currents, waves, or water crafts present which
could create wakes. Do not use in any other body of water or in salt water.
• This product is designed to hold one person not exceeding 200 lbs.
• Keep hands, hair, and loose objects such as clothing away from the propeller.
• If an object becomes lodged in the propeller, make sure that this product is turned off before attempting to dislodge.
• Always inspect the pool area before use to ensure it is free of hazards and/or obstacles, such as pool toys and
swimmers.
• Never ride into or over swimmers.
• Keep this product away from hot or sharp objects.
• Always use caution and common sense.
• Never jump or dive off this product.
FCC Part 15 Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including inter-
ference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable l interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer
-
ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
6