Filter
Top Products
SPECIAL CARE & HANDLING
• Avoid rough handling such as bumping or dropping.
• Avoid moisture and extreme temperatures. For
best results, use between the temperatures of 39ºF and
100ºF (4º C and 38º C).
• Never drive your 1:12 Ford GT on a wet floor, on sand,
or in mud, rain or snow. These can damage it.
• Be sure to remove the batteries from your 1:12 Ford Mustang
and transmitter when storing the product.
• To protect your 1:12 Ford GT’s wheel mechanism from
lint, thread, hair and dust particle, you can use a small brush,
tweezers or tie a small bit of cloth to the tip of a toothpick,
etc., and wipe it off.
• Always keep your 1:12 Ford GT clean. Use a dampened
cloth to wipe off, and then wipe all the water off with a dry
cloth. Never use chemicals to clean the product.
• Avoid holding the wheels when rotating. Holding them will
cause the electronic components to short-circuit, overheat and
malfunction.
8 9
If you lose control of your
1:12 Ford GT, please check
the following potential
cause:
1. Another radio control
vehicle using the same fre-
quency is operating near
your vehicle. If that is the
case, you should race other
vehicles that use different
frequencies or channels.
If your 1:12 Ford GT
drives slowly, please check
the following potential
cause:
1. There are weak batter-
ies in the transmitter. If that
is the case, replace with
new batteries.
2. There is strong inter-
ference in the surrounding
area. If that is the case, you
should move to a better
location to drive your 1:12
Ford GT.
Caution
• Do not operate your 1:12 Ford GT in thunderstorms.
• Do not touch the wheels when the switch is turned ON.
• Do not leave your 1:12 Ford GT or transmitter near
sources of heat or under direct sunlight for long periods
of time.
• Do not operate your 1:12 Ford GT near small children.
• Do not drive your 1:12 Ford GT in busy streets. Always
choose a safe place to play.
ENGLISH ENGLISH