Filter
Top Products
Catalog Part #70402
Brochure No. 63-0164
©2003 Edelbrock Corporation
Rev. 02/03
Page 14 of 25
2.9 Fuel Pump Installation (Continuation)
5. Measure and cut a length of the supplied fuel hose from the outlet of the fuel pump to the fuel hose that runs
towards the engine compartment. Connect one end of the cut fuel hose to the barb fitting on the outlet side of
the fuel pump and secure with one of the supplied hose clamps.
6. Install the male Ford Fuel Hose Adapter into the remaining end of the fuel hose and secure with one of the
supplied hose clamps. Connect the male Ford Fuel Hose Adapter into the female Ford Fuel Hose Connector
and secure with the supplied replacement Ford Clip as shown in the illustration below.
7. Turn the ignition to the “on” position without starting the vehicle and check the fuel fittings and hoses for leaks.
Double check to make sure that everything is securely mounted and away from moving components or sources
of heat.