Filter
Top Products
Catalog #70080, #70081, #70082, #70083
Brochure No. 63-0312
©2008 Edelbrock Corporation
Rev. 07/08
Page 19
2.13 2-Stage Electrical System Installation
Nitrous Electrical Components Bill of Materials (BOM)
Nomenclature Descriptions:
ATO… the fuse configuration is ATO. When replacing this fuse, ask for an ATO fuse.
“a”… Amperage.
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical
systems only. Before attempting to wire your Edelbrock Performer nitrous oxide system, examine and follow
the wiring diagram on the following page. Please call the Edelbrock Technical department with any
questions concerning electrical wiring.
When working with electrical systems in your vehicle, it is a good idea to have a service manual that features
your vehicle. It is also good practice to have a book that specializes on the specialized techniques required
when working with vehicular electrical systems.
Quantity Description
1 ea.
Activation microswitch
1 ea.
Activation microswitch bracket (not shown)
2 ea.
Activation microswitch mounting nut
2 ea.
Activation microswitch mounting screw
2 ea.
30 amp relay
2 ea.
Wire harness with integral relay/fuse holder
1 ea.
Red lighted toggle switch
6 ea.
18/22g female spade connector, Nylon insulated
2 ea.
14/16g female spade connector, Nylon insulated
2 ea.
14-16g male spade connector, Nylon insulated
3 ea.
16/18g, splice connector
5 ea.
14/16g 3/8” ring terminal, Nylon insulated
1 ea.
Male blade fuse tap
1 ea.
Nitrous 2nd stage pushbutton
1 ea.
30 amp ATO blade fuse
1 ea.
15 amp ATO blade fuse
2 ea.
18/22g female spade connector, Nylon insulated (.187)