Filter
Top Products
Catalog #70005
Rev. 07/08 - AJ/mc
©2008 Edelbrock Corporation
Brochure No. 63-70005
Page 10 of 20
2.2 2-Stage Electrical Components Bill of Materials (BOM)
Nomenclature Descriptions:
ATO… the fuse configuration is ATO. When replacing this fuse, ask for an ATO fuse.
“a”… Amperage.
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical systems only.
Before attempting to wire your Edelbrock Performer nitrous oxide system, examine and follow the wiring diagram on
the following page. Please call the Edelbrock Technical department with any questions concerning electrical wiring.
When working with electrical systems in your vehicle, it is a good idea to have a service manual that features your vehicle.
It is also good practice to have a book that specializes on the specialized techniques required when working with
vehicular electrical systems.
Quantity Description
1 ea. Activation microswitch
1 ea. Activation microswitch bracket (not shown)
2 ea. Activation microswitch mounting nut
2 ea. Activation microswitch mounting screw
1 ea.
30 amp relay
1 ea. Wire harness with integral relay/fuse holders
1 ea. Red lighted toggle switch
6 ea. 18/22g female spade connector, Nylon insulated
2 ea. 14/16g female spade connector, Nylon insulated
2 ea. 14-16g male spade connector, Nylon insulated
3 ea. 16/18, splice connector
5 ea. 14/16g 3/8” ring terminal, Nylon insulated
1 ea. Male blade fuse tap
1 ea. 14/16g male spade connector, Nylon insulated
1 ea. Nitrous 2nd stage push button
1 ea. 30 amp ATO blade fuse
1 ea. 15 amp ATO blade fuse
2 ea. 18/22g female spade connector, Nylon insulated
The picture at right shows a typical solenoid installation.