Filter
Top Products
Catalog #66032, #66033
©2006 Edelbrock Corporation
Page 3 of 3
Brochure #63-66032
Rev. 9/06 - DA/mc
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: 1-800-416-8628
E-Mail: Edelbrock@Edelbrock.com
Fig. 2
Modified Large Alternator Brace Installed (Arrow)
Fig. 1
Right Side Hardware Locations
• FINAL INSPECTION
1. Check all lines (hydraulic, vacuum, air
conditioning and fuel) to ensure there is
adequate clearance to T.E.S. components.
Note especially a/c lines on right side; secure
away from T.E.S.
2. Re-connect battery.
3. At this point it is a good idea to look everything over
and make sure that nothing was missed in
assembly.
4. Start vehicle and bring up to normal operating
temperature. Check for possible leaks.
5. Turn engine off and let cool. Tighten all bolts again.
KIT CONTENTS
Catalog #66032 (Ceramic-Coated), #66033 (Ti-Tech Coated)
Qty. Description
❑ 1 Header left side #25-9313 (#66032)
❑ 1 Header right side #25-9314 (#66032)
❑ 1 Header left side #25-9090 (#66033)
❑ 1 Header right side #25-9091 (#66033)
❑ 1 Extension pipe right #25-9597
❑ 12 Hex header bolts; 3/8” - 16 x 1”
❑ 1 Hex header bolt; 3/8” - 16 x 1-1/4”
❑ 1 Hex header bolt; 3/8” - 16 x 2”
❑ 2 Chevrolet V8 port gaskets
❑ 1 Donut gasket; 2-1/4”
Qty. Description
❑ 1 Catalytic converter gasket
❑ 3 Hex nuts; 3/8” - 16
❑ 3 Hex bolts; 3/8” - 16 x 1-1/2”
❑ 2 Hex bolts; 3/8” - 16 x 2”
❑ 1 Spacer tube; 5/8” O.D. x 3/4”
❑ 3 Flat washers; 3/8”
❑ 17 Lock washers; 3/8”
❑ 4 Hardened washers; 3/8” I.D. x 1/8”thick
❑ 1 Alternator bracket
2” Header bolt, 3/4”
spacer, lockwasher, and
hardened flat washer for
small alternator bracket
assembly
1-1/4” Header bolt
& lockwasher
1” Header bolt &
lockwasher
Front
Large Alternator
Bracket