Eclipse - Fujitsu Ten AVN 5500 GPS Receiver User Manual


 
-
6
-
Never cut the insulation on the power wire or use it to power any other equipment. If the rated current capacity of the power wire
is exceeded, fire and electric shocks may result.
The wires should be secured with tape or a similar securing method to prevent any obstructions while driving. If they get wound
or entangled around components such as the steering wheel, shifting lever, or brake pedal, accidents may result.
If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire insulating method around
the connection to insulate it. If the connection is not insulated, fire or accidents may result.
Name and functions of ter
Name and functions of ter
minals
minals
1
2
3
4
5
6P
13P
GPS ANTENNA
10
10
10P
A
6
7
9
11
12
13
G
F
E
D
C
H
ANTENNA PLUG
MAIN UNIT
1P
1
INTERCONNECTING WIRES
(Video input Video input and
steering remote control
connectorconnector)
4
INTERCONNECTING WIRES
(Rear speaker connector )
3
INTERCONNECTING WIRES
(Power and front speaker connector)
2
B
Refer to page 7 for details on the wire colors and connection points for interconnecting wires , and
and .
Refer to page 8 for details on connection points , , , , , and
for the main unit wires and terminals.
43
2
Tip
A B C D E H
Use supplied wire harness with this main unit. Other manufacturers may use a similar wire harness connector but pin
configurations are incorrect for use with Eclipse main units and can damage the main unit. Prior to powering up the main unit,
please make sure the main unit is properly grounded with the vehicle chassis. If no ground is available to the chassis, add a
ground strap from the main unit to the vehicle chassis to improve the ground.
Do not use with speakers having 1 to 3 ohms impedance. This main unit is designed to be used with high-powered speakers
rated above 50w with impedance rating between 4 and 8 ohms.
8
English Español Français Italiano
Nederlands
SvenskaEnglish
8P