Filter
Top Products
Route the parking brake signal wire to the main
unit.
-
11
-
Foot-operated
Parking brake
Hand-operated
Parking brake
-
A connecting the point for parking brake (example)
-
Attach a splicing
connector at this location.
Reverse signal wire
Reverse lamp
Reverse signal wire
-
A connecting point for the reverse signal (example)
-
••
Be sure to connect the reverse signal wire. If it is
not connected, the vehicle position may be
incorrect when the vehicle is reversed.
••
Use a circuit tester to confirm that a sensing
voltage of 6 V or higher is generated when the
vehicle is reversed.
Tip
-
Using the splicing connector
-
Insert the connection wire [vehicle speed pulse
signal wire (purple/white), parking brake signal
wire (red/white), or reverse signal wire (green)]
from the main unit and the vehicle wire into the
splicing connector.
1
Push in the terminal (the metal part) of the
splicing connector using a pair of pliers.
2
Harness in the car
Vehicle speed pulse signal wire
(purple/white), parking brake wire,
(red/white) or reverse wire (green)
Splicing connector
8
Press down the cover of the splicing connector
and squeeze it until it locks.
3
Lock
Splicing connector
8
Use a splicing connector to connect the reverse
signal wire (green) coming from the main unit to
the reverse signal wire of the vehicle.
1
Route the reverse signal wire to the main unit .
2
Use a splicing connector to connect the parking
brake signal wire (red/white) coming from the
main unit to the parking brake signal wire of the
vehicle.
1
2
Parking brake
Signal Wire
Attach a splicing
connector at this location.
Parking brake
signal wire
Español Français Italiano
Nederlands
SvenskaEnglish