Filter
Top Products
– If installing underneath a rear spoiler (example) –
Wipe the installation surface free of any dirt, water or
grease.
6
Peel off the backing paper from the double-sided
tape on the bracket, and affix the bracket to a flat
part of the back door.
7
•
After affixing the bracket, push the bracket
firmly on the mounted surface ensure that it
is securely attached.
•
The adhesive strength of the double-sided
tape will be reduced at low temperatures
(20˚C) or less. Use a hair dryer or a similar
technique to warm the double-sided tape
before attaching it.
Tip
– If installing directly to the back door (example) –
Install the rear camera to the bracket.
8
•
Install so that the "ECLIPSE" logo is facing
upward.
Tip
Front of vehicle
Front of
vehicle
Bracket
2
Bracket
2
Rear camera
1
Screw
(M3x6)x 2
3
– If installing directly to the back door (example) –
Pull the rear camera cable inside the back door
while securing it with the cable rails.
9
•
The cable rails should be cut to appropriate lengths.
Tip
Front of
vehicle
Cable rail
5
Rear camera
1