Eclipse - Fujitsu Ten BEC105 Automobile Electronics User Manual


 
System connection e
System connection e
xample
xample
Never cut the insulation on the power cable or use it to power any other equipment. If the rated current capacity
of the power cable is exceeded, fire and electric shocks may result.
The cables should be bound together with tape or with a similar technique so that they do not interfere with
driving. If they become wound around parts such as the steering wheel, shifting lever or brake pedal, accidents
may result.
Install all components and route the cables before connecting up the main unit.
The terminals at the rear of the main unit will vary depending on the type of main unit used. Always be sure to
refer to the installation manual for the main unit.
If any cables are unconnected, wrap their ends with PVC tape or a similar technique to insulate them.
Tip
BEC105
1
MAIN UNIT
(sold separately)
4P
GPS ANTENNA
(Supplied with main unit)
ANTENNA EXTENSION CABLE
Be sure to use when connecting the
radio antenna to the vehicle.
ANTENNA
PLUG
INTERCONNECTING CABLE
(Supplied with main unit)
1P
INTERCONNECTING CABLE
(Supplied with main unit)
TO BATTERY+12V
(Permanent Supply)
TO ACC (Power Supply)
TO POWER ANTENNA RELAY (Supply)
TO TURN-ON LEAD OF EACH UNIT (Supply)
REAR
SPEAKERS
FRONT
SPEAKERS
TO HEAD LIGHT SWITCH (Illumination)
Red
Orange/White
Blue
Blue/White
Yellow
Black
TO GROUND
20P
16P
090003-28750700
0507DE CN)