Eclipse - Fujitsu Ten AVN2454 GPS Receiver User Manual


 
-
12
-
System connection e
System connection e
xample
xample
Never cut the insulation on the power cable or use it to power any other equipment. If the rated current
capacity of the power cable is exceeded, fire and electric shocks may result.
The cables should be secured with tape or similar item so it will not cause an obstruction while driving.
If they get wound around components such as the steering wheel, shifting lever or brake pedal,
accidents may result.
Install and connect all of the peripheral units before connecting them to the main unit.
Do not remove the caps of pin jacks unless in use.
Be sure to wrap the connection cables with plastic tape to insulate them.
Tip
FRONT
REAR
NON FADER
(do not remove cap)
6P
13P
ANTENNA EXTENSION CABLE
Be sure to use when connecting the
radio antenna to the vehicle.
6
GPS ANTENNA
11
10P
5P
ANTENNA
PLUG
TO MONITOR
MAIN UNIT
1
TO BATTERY+12V
(Permanent Supply)
TO BATTERY+12V
(Permanent Supply)
TO ACC (Power Supply)
TO POWER ANTENNA RELAY (Supply)
TO TURN-ON LEAD OF EACH UNIT (Supply)
NO
CONNECTION
Black
Black
FRONT
SPEAKERS
TO HEAD LIGHT SWITCH (Illumination)
1P
4P
BEC104
(sold separately)
6P
TO PARKING
BRAKE SIGNAL
(Refer to page 10)
TO VEHICLE
SPEED PULSE
SIGNAL TERMINAL
TO REVERSE SIGNAL
(Refer to page 10)
CH3083
(sold separately)
DIN CABLE
(Supplied with CD changer)
POWER CONNECTOR CABLE
(Supplied with CD changer)
TO STEERING REMOTE
CONTROL
13P
2P
TO GROUND
TO GROUND
Red
Purple/White
Red/White
Green
Orange/White
Blue
Blue/White
Yellow
Yellow
Yellow
White
Red
TO EXTERNAL VIDEO EQUIPMENT
INTERCONNECTING
CABLE
(Speed pulse parking brake
and reverse signal connector)
4
INTERCONNECTING CABLE
(Video input connector)
5
INTERCONNECTING CABLE
(Rear speaker connector)
3
INTERCONNECTING
CABLE
(Power and front
speaker connector)
2
REAR
SPEAKERS