Filter
Top Products
To Service the Battery:
1. Remove the floor portion of the rear compartment
carpet to access the battery compartment.
2. Remove the battery cover mounting screws and re-
move the battery cover.
3. Disconnect the negative battery cable from the battery.
NOTE: The negative battery terminal is marked with a
(-) symbol. The positive battery terminal is marked with
a (+) symbol.
4. Disconnect the positive battery cable from the battery.
5. Remove or loosen the battery retainer clamp and bolt.
6. Lift out the battery.
7. Clean out the battery tray area, freeing area of dirt,
stones, and battery acid.
8. Clean and inspect the battery terminals and replace if
parts are damaged or unusable.
9. Place the battery in the tray.
10. Tighten the battery retainer clamp and bolt down.
11. Connect the positive battery cable to the battery
positive terminal and tighten.
NOTE: The negative battery terminal is marked with a
(-) symbol. The positive battery terminal is marked with
a (+) symbol.
12. Connect the negative battery cable to the battery
negative terminal and tighten.
13. Install the battery cover and tighten down the screws.
14. Install the carpet in the floor portion of the rear
compartment.
MAINTAINING YOUR VEHICLE 209
7