Filter
Top Products
CAUTION!
Do not crank engine for more than 15 seconds at a
time or starter motor damage may result. Turn key to
OFF and wait at least 2 minutes for starter to cool
before repeating start procedure.
•
The WAIT TO START light will remain on for a period
of time (length of time depends on engine tempera-
ture).
•
After the WAIT TO START light goes off, turn the
ignition key to START. Do not press the accelerator
during starting.
•
After engine start-up, check to see that there is oil
pressure.
•
Allow the engine to idle about three minutes until
the manifold heaters have completed the post-heat
cycle.
•
Release the parking brake and drive.
NOTE: Engine idle speed will automatically increase to
1000 rpm at low coolant temperatures to improve engine
warm-up.
NOTE: If the engine stalls or if the ignition switch is left
On for more than 2 minutes after the WAIT TO START
light goes out, reset the grid heaters by turning the
ignition switch to Off for at least 5 seconds and then back
On. Repeat steps 3 through 7 of the normal starting
procedure.
For Extremely Cold Weather Starting — Engine
Manifold Air Temperature Below 0°F (- 18°C)
In extremely cold weather below 0°F (- 18°C) it may be
beneficial to cycle the manifold heaters twice before
256 STARTING AND OPERATING