Filter
Top Products
5. Remove the dipstick and feel if the fluid is hot or
warm. Hot fluid is approximately 180°F (82°C), the
normal operating temperature after the vehicle has been
driven at least 15 miles (24 km). The fluid cannot be
comfortably held between the finger tips. Warm is when
fluid is between 85° and 125°F (29° and 52°C).
6. Wipe the dipstick clean and reinsert until seated.
Remove dipstick and note reading.
a. If the fluid is hot, the reading should be in the
crosshatched area marked “OK”.
b. If the fluid is warm, the reading should be between
the two holes.
If the fluid level is low, add sufficient fluid to bring to the
proper level.
Fluid is added through the dipstick tube.
NOTE: To prevent dirt and water from entering the
transmission after checking or replenishing fluid, make
certain that the dipstick cap is properly reseated.
Fluid Level Check – 4.7L/5.7L Engine
Check the fluid level while the transmission is at normal
operating temperature 180°F (82°C). This occurs after at
least 15 miles (24 km) of driving. At normal operating
temperature the fluid cannot be held comfortably be-
tween the fingertips.
To check the automatic transmission fluid level properly,
the following procedure must be used:
1. Operate the engine at idle speed and normal operating
temperature.
2. The vehicle must be on level ground.
3. Fully apply the parking brake and press the brake
pedal.
316 MAINTAINING YOUR VEHICLE