Directed Electronics 650 ESP Automobile Alarm User Manual


 
9
©
1999 Directed Electronics, Inc.
Pressing the arm button a second time within five seconds:
The siren chirps twice followed by a long chirp. Zone Two is
now bypassed.
Pressing the arm button a third time within five seconds: The
siren chirps three times followed by a long chirp. Zone Four
is now bypassed.
Pressing the arm button a fourth time within five seconds:
The siren chirps four times followed by a long chirp. Zones
Two and Four are now bypassed.
Pressing the arm button a fifth time within five seconds: The
siren chirps five times followed by a long chirp. All input
zones, except the ignition, are now bypassed.
NOTE: Multi-Level Security Arming only applies to a single arming cycle.
Once the system is disarmed and then re-armed, all the zones will be
active again.
Your system can be armed while driving the vehicle! Simply press
on your transmitter for 1.5 seconds while the vehicle is run-
ning, or the ignition is on. The system will chirp once and then
once more to indicate that the ignition is on. The system will not
respond to any input except the door triggers and the starter kill
relay (if installed) will not be activated. The system will disarm
automatically when the ignition is turned off. The siren will chirp
twice and the LED will stop flashing.
NOTE: If programmed for the optional Vehicle Recovery System (VRS)
feature, arming with the transmitter will arm the VRS feature. (See VRS
section of this guide.)
Arming While Driving