Filter
Top Products
19
©
1999 Directed Electronics, Inc.
Power Saver Mode
Your security system will automatically enter Power Saver Mode
while armed or in Valet
®
Mode, after a period of time in which no
operation has been performed. This lowers the current draw to pre-
vent the security system from draining the vehicle’s battery. Power
Saver Mode takes over under the following conditions:
■ Power Saver when the system is armed: After the system has
been armed for 24 hours, the LED will flash at half its normal
rate decreasing the system's current draw.
■ Power Saver in Valet
®
Mode: When the system enters Valet
®
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet
®
Mode, the LED will shut off. If the system
remains in Valet
®
Mode, the LED will come back on the next
time the ignition is turned on and then back off.
Programming Options
Programming options control what your system does during nor-
mal operation, and require few or no additional parts. However,
some may require additional installation labor.