Filter
Top Products
11
©
1999 Directed Electronics, Inc.
and know where the Valet
®
switch is located. Be sure to check with
the installer for the location of the Valet
®
switch.
To disarm the security system,
turn the ignition to the "on"
position. Press the Valet
®
switch
the pre-programmed number of
times (1-5 times) within 15
seconds. The system should now
disarm. If it does not, you may
have waited too long, so turn
the ignition off and on and try
again.
IMPORTANT! The unit can be programmed to respond to 1-5 pulses of
the Valet
®
switch for the disarm function. Be sure to check with the
installer for the desired programming.
To temporarily turn off the arm or disarm chirps, use Silent Mode
™
.
Simply press briefly before arming or disarming, and the
confirmation chirp(s) will be eliminated for that one operation
only. If you want the arm/disarm chirps turned off permanently,
your dealer can do this for you.
NOTE: The Warn Away
®
response to lighter impacts is bypassed if the sys-
tem is armed using Silent Mode. This ensures that no chirps will be emit-
ted by the siren in an area you want chirp-free. The system is still fully
capable of triggering. Only the Warn Away response is bypassed.
Silent Mode
DRW-35