Directed Electronics Avital 2300 Automobile Alarm User Manual


 
8
©
2001 Directed Electronics, Inc.
you time to disarm the security system with your remote
transmitter, in case the door is inadvertently opened while
the system is armed.
Turning on the ignition key triggers the same two-stage pro-
gressive response as opening a door.
The starter interrupt prevents the vehicle’s starter from cranking.
Press to disarm the security system when it is already armed.
If the power locks are controlled by the system, the doors will also
unlock. Disarming is confirmed when the parking lights flash twice
and the siren emits two chirps. The status LED will also stop flash-
ing. The siren chirping either four or five times when disarming
indicates Tamper Alert, which is described in the Diagnostics
section of this guide.
If your remote transmitter is lost or damaged, you can manually
disarm the security system. To disarm the system without a trans-
mitter, you must have the vehicle's ignition key and know where
the Valet switch is located. Be sure to check with your installer at
the time of installation for the location of the Valet switch.
To disarm the security system, turn
the ignition key on and press the
Valet switch within 15 seconds. The
system should now disarm. If the
system does not disarm, you may
DRW-35
Disarming Without a Transmitter
Disarming