Filter
Top Products
13
©
2000 Directed Electronics, Inc.
To perform Valet
®
Take-Over:
1. Before turning off the engine, press and release and
on the transmitter (or press and release the optional momen-
tary switch).
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses or
a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
NOTE: This feature will not work if the brake pedal is being pressed.
Timer Mode automatically starts the engine and runs it for a
pre-programmed time period, every three hours for a total of
six operation cycles. This feature helps to ensure that your
engine will start in the morning after a night of extremely cold
temperatures.
IMPORTANT! This feature must only be used in open areas, never in an
enclosed area such as a garage.
To enter Timer Mode:
1. Start the vehicle by pressing and releasing and .
2. Press and release .
3. Within two seconds press and release and again.
4. The engine will shut down and the parking lights will flash
four times. The engine will then restart to confirm that Timer
Mode has been entered.
Timer Mode