Directed Electronics 650 Automobile Alarm User Manual


 
To disarm with the transmitter during a trigger, press Button I on your
transmitter.The siren will stop sounding. Next press Button I once more
and the system will chirp four or five times (reporting the trigger) and
disarm.
Disarming Without a Transmitter
This feature allows you to disarm the system without the transmitter
should it be lost, damaged or disabled. In order to disarm without a
transmitter, you must have the vehicle's ignition key and know where
the valet button is. Be sure to check with the installer for the location of
the Valet button.
Turn on the ignition. Push the Valet
®
switch within
15 seconds. The system should now disarm. If it
does not, you may have waited too long, so turn
the ignition off and on and try again.
Silent Mode
TM
To temporarily turn off the arm or disarm chirps, use Silent Mode
TM
.
Simply press Button II briefly before arming or disarming, and the con-
firmation chirp(s) will be eliminated for that one operation only. If you
want the arm/disarm chirps turned off permanently, your dealer can do
this for you.
NOTE: The Warn-Away response to lighter impacts is bypassed if the system is armed using Silent Mode. This
ensures that no chirps will be emitted by the siren in an area you want chirp-free. The system is still fully able to
trigger. Only the Warn-Away response is defeated.
Panic Mode
If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your transmitter! Just press Button I for
1.5 seconds, and you will enter Panic Mode. The siren will sound and
the parking lights will flash for 30 seconds. To stop Panic Mode at any
time, press Button I on the transmitter again.
5
© 1994, 1997 Directed Electronics, Inc. 97G432.597