Directed Electronics 571XV Automobile Alarm User Manual


 
20
© 2005 directed electronics—all rights reserved
valet take-over
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle
for short periods of time, but would like to leave the motor
running and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release on the 2-
way remote twice within 3 seconds. Then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous
Remote
Start
section for a complete list of shut-down inputs.)
4. The remote start responds with remote start tones and the
Yellow LED illuminates for 3-seconds.
short-run/turbo
Short run turbo mode keeps the engine running after arriving at
note: This feature will not work if the brake pedal is
pressed.
note: If the remote start is on the lights will turn off then
flash 3-times before returning to their normal output and
the defogger output will activate as programmed.