Filter
Top Products
33
© 2002 directed electronics, inc.
QUICK REFERENCE GUIDE
To arm using your remote
➤ You can activate, or arm, the system by pressing on your transmitter for one
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle’s power door locks have been
connected to the system, the doors will lock.
To disarm using your remote
➤ To disarm the system, press . You will hear two chirps, and the parking
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
➤ Press on your transmitter for two second while the vehicle is running. The
system will chirp once and then once more to indicate that the ignition is on.
Disarming without a transmitter
➤ Turn on the ignition. Press the Valet button the programmed number of times
within 15 seconds. After five seconds, the system will disarm. If it does not, you
may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
➤ Turn ignition to RUN position, then turn to OFF position. Press and release
the Valet button within 10 seconds. The status LED will light solid if you are
entering Valet Mode, and it will go out if you are exiting Valet Mode.
To activate Panic Mode
➤ Press and hold down for one second.
To exit Panic Mode
➤ Press on the transmitter.
To activate Silent Mode™
➤ Press briefly before arming or disarming, and the confirmation chirp(s)
will be eliminated for that one operation only.
Location of Valet Button_______________________________
Number of Valet Button pulses for disarming_____________
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂✂
✂✂