Directed Electronics 436 Series Automobile Alarm User Manual


 
29
© 2002 directed electronics, inc.
Input
: A physical connection to the system. An input can be
provided by a sensor, pinswitch or through an existing system in
the vehicle, such as ignition or courtesy lights.
LED
: Red light mounted somewhere in the vehicle. It is used to
indicate the status of your system. It is also used to report trig-
gers and faults in the system or sensors.
Shock Sensor
: This is a sensor mounted in the vehicle that is
designed to pick up impacts to the vehicle or glass.
Siren
: Noise generating device usually installed in the engine
compartment of the vehicle. It is responsible for generating the
"chirps" you hear, as well as the six tones you hear while the
alarm is triggered.
Transmitter
: Hand-held, remote control which operates the
various functions of your system.
Trigger or Triggered Sequence:
This is what happens when the
alarm "goes off" or "trips". The triggered response of your
system consists of the siren sounding and parking light flashing
for the programmed duration.
Valet Switch
: A small push-button switch mounted somewhere
inside the vehicle. It is used to override the alarm when a trans-
mitter is lost or damaged, or to enter or exit Valet mode.
Warn Away Response:
Lighter impacts to the vehicle will generate
the Warning Zone response. It consists of several seconds of siren
chirps and parking light flashes.