Filter
Top Products
12
© 2008 Directed Electronics. All rights reserved.
the ON position, the engine will shut down.
While the vehicle is running during remote start operation, the system
will monitor the vehicle and will automatically shut down the engine if
the system receives any of the following shut-down inputs:
The brake pedal is pressed.•
The hood is opened.•
The shutdown toggle switch is put into the ON position.•
The pre-programmed run time has elapsed.•
The single button is pressed and held for 3 seconds.•
➢ Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
To perform Valet Take-Over:
Before turning off the engine, press and release the single button 1.
once within 2 seconds.
Turn the ignition key to the OFF position. (The engine will stay 2.
running.)
The engine will run until the pre-programmed time 3.
elapses or a shut-down input is received. (See the
previous Remote Start section for a complete list
of shut-down inputs.)
Note:
This feature will not work if the brake pedal is
being pressed.