Directed Electronics 410 Automobile Alarm User Manual


 
7
©
1999 Directed Electronics, Inc.
grammed for passive mode, it will automatically activate the
Failsafe® Starter Kill relay 30 seconds after the ignition is turned
off. Passive mode is indicated by rapid flashing of the LED after the
ignition is turned off.
NOTE: For passive mode to be effective, the Failsafe® Starter Kill relay
must be installed.
If passive mode is programmed on, it is also possible to program
the system to lock the doors automatically. This is called passive
locking. If passive locking is turned on, care must be taken to pre-
vent the keys from being locked in the vehicle.
To disarm the security system and unlock the doors of the vehicle,
press for one second. The Failsafe® Starter Kill will be deac-
tivated and the vehicle’s horn (if connected) will honk twice. The
parking lights will also flash twice (if connected). The red status
LED will go out, unless the system is programmed for passive mode.
If programmed for passive mode, the LED will begin to flash rapid-
ly when the system is disarmed. This indicates that the security
system will re-engage the Failsafe® Starter Kill relay and re-lock
the doors (if passive locking is selected) in 30 seconds unless the
key is turned on.
NOTE: If the system has been armed with the remote transmitter, you
must use the transmitter or the Valet switch to disarm the system and
deactivate the starter kill. Manually unlocking the vehicle does not dis-
arm the system; it will only unlock the doors.
Disarming/Unlocking