Filter
Top Products
6
© 2007 Directed Electronics-all rights reserved
Disarming
To disarm the system, unlock the doors using your factory keyless trans-
mitter. The siren will sound twice, and the parking lights will flash twice.
If the siren sounds either four or five times when disarming, refer to the
Diagnostics section of this guide. This is called Tamper Alert.
Disarming without a transmitter
This feature allows you to override the system without the transmitter
should it be lost, damaged or disabled. To do this, you must have the ve-
hicle's ignition key and know where the integrated LED/Valet
®
switch is
located. The Valet
®
switch is activated by pressing the LED status indicator.
Turn the ignition to the “run”position.
Press and release the integrated
LED/Valet
®
switch, within 10 seconds.
After a few seconds the LED will stop
flashing and the vehicle should start. If it does not, you may have waited
too long. Turn the ignition off and try again.
nnoottee::
The setting for the number of times the integrated
LED/Valet® switch must be pressed is set in the
Programming Section of this guide.
DRW-35
Integrated
LED/Valet
®
switch
LED status indicator