Filter
Top Products
38
© 2008 Directed Electronics. All rights reserved.
Owner recognition
Owner recognition lets up to four users of the system have unique settings that
meet their specific needs. It is almost like having four separate systems in your
vehicle, one for each user. This feature is only available to authorized dealers
using the Bitwriter or Bitwriter 2 program tool.
Rapid resume logic
This Directed system will store its current state to non-volatile memory. If power is
lost and then reconnected the system will recall the stored state from memory.
For example, if the unit is in Valet Mode and the battery is disconnected for any
reason, such as servicing the car, when the battery is reconnected the unit will
still be in Valet Mode. This applies to all states of the system including lock or
unlock.
Power saver mode
➤ System
Your system automatically enters Power Saver Mode while locked or in Valet
Mode, after a period of time in which no operation has been performed. This
lowers the current draw on the vehicle’s battery. Power Saver Mode takes over
under the following conditions:
Power Saver when the system is locked: After the system has been Locked for
24 hours the LED will flash at half its normal rate, decreasing the system’s cur-
rent draw.
Power Saver in Valet Mode: When the system enters Valet Mode the Status LED
on the Responder LC control center illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one-hour period while the system is in Valet Mode,
the status LED will shut Off. If the system remains in Valet Mode, the LED will
come back on the next time the ignition is turned on and then back Off.