Filter
Top Products
16
©
2004 Directed Electronics, Inc.
■ After the remote start module has been installed, contact
your authorized dealer to have him or her test the remote
start module by performing the Safety Check outlined in the
product installation guide. If the vehicle starts when per-
forming the Neutral Safety Shutdown Circuit test, the remote
start unit has not been properly installed. The remote start
module must be removed or the installer must properly rein-
stall the remote start system so that the vehicle does not
start in gear. All installations must be performed by an
authorized Directed Electronics dealer. OPERATION OF THE
REMOTE START MODULE IF THE VEHICLE STARTS IN GEAR IS
CONTRARY TO ITS INTENDED MODE OF OPERATION. OPER-
ATING THE REMOTE START SYSTEM UNDER THESE CONDI-
TIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL
INJURY. YOU MUST IMMEDIATELY CEASE THE USE OF THE
UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED
DIRECTED ELECTRONICS DEALER TO REPAIR OR DISCONNECT
THE INSTALLED REMOTE START MODULE. DIRECTED ELEC-
TRONICS, INC. WILL NOT BE HELD RESPONSIBLE OR PAY
FOR INSTALLATION OR REINSTALLATION COSTS.
Pressing for one second arms the system by activating the
starter kill and locking the doors (if the door locks are connect-
ed). The horn will honk (if connected) and the parking lights will
flash once to confirm arming of the system. While the system is
armed, the status LED will flash once per second. The Failsafe
®
Locking