Filter
Top Products
8
REMOTE CONTROL SETTING
Certain functions on the remote may be set to your convinience.
To access the remote control programming mode, press the
button located on the back of the remote and hold it for 5
seconds.
The remote beeps once to endicate entering programming mode.
PAGER
The system is equipped with a function called ‘Pager’. The purpose of this function is to send a general call asking those
who carry them to get to the vehicle or to perform a task previously established.
Paging
To send a general call, the user must press the ‘Valet’ switch and hold it for 3 seconds while engine is stopped
and key is
not in the ignition
, or while engine is remote started (see ‘Valet Mode’ on page 16)(The valet switch is a small push button
hided under the dash board).
Parking lights on the vehicle blink once to confirm the call was sent.
All remote controls (maximum: 4) located within the radio frequency range of the vehicle will begin to chirp. To silence the
remote control, press any button.
REMOTE TRANSMITTER PROGRAMMING TABLE
PARAMETERS SETTINGS BUTTONS DISPLAY / REMARKS
Lock
/ 1 BEEP
Keyboard Un/Lock
Unlock
/ 2 BEEPS
Disabled
/ 1 BEEP
Mute
Enabled
/ 2 BEEPS
Enabled
/ 1 BEEP
Status confirmations
Disabled
/ 2 BEEPS
Trunk
Motion sensor
Glass breakage sensor
Tilt sensor
Auxiliairy sensor icon
Ultrasonic sensor
1 BEEP
2
BEEPS
3
BEEPS
4
BEEPS
5
BEEPS
Upon "Status" command
Upon any command
T
HE DISPLAY LIGHTS-UP
FOR 3 SECONDS
Back-light
Never
BACK-LIGHT SHUTS OFF
Number of vehicle 1 – 4 (Default setting : 2)
1
2 3 4
LEGEND : DISPLAYED ICON (BLACK) : MASKED ICON (GRAY) : DEFAULT SETTING