Filter
Top Products
7
CONFIRMATIONS EMITTED BY THE REMOTE
An audible confirmation (piezo) and a visual confirmation (LCD display) are emitted each time a command is transmitted.
The LCD displays the vehicule status at all time, the display is refreshed on every transmission or when the status of the
vehicle changes pertaining that the “Status confirmation” function is enable. The display shows the last confirmation
received.
The following diagram shows the usefulness of each icon of the display.
Descriptions in CAPITAL letters show confirmations pertaining to the security system’s functions.
1 Transmission 14 Battery charge indicator
2 Vehicle out of range 15 Auxiliairy outputs status
3 Reception 16 Sentinel mode status
4 Unlocking 17 SECURITY SYSTEM STATUS
5 Locking 18 ULTRASONIC SENSOR
6
PRE-ALERT
MD
19 IGNITION STATUS SENSOR
7
Panic / PRE- ALERT
MD
/ ALARM
20 TILT SENSOR
8 ALARM 21 Remote starter status
9 SHOCK SENSOR 22 HOOD STATUS
10 FEILD DISTURBANCE SENSOR 23 TRIGGERED ZONES
11 TRUNK LID STATUS 24 Valet mode status
12 GLASS BREAKAGE SENSOR 25 Vehicle identification
1 2 3 4 5 6
15
24
23
22
21
20
19
18
17
8
9
10
11
12
13
16
14
25
7
13 DOORS STATUS
Two types of confirmations are displayed on the remote :
Command confirmation: These confirmations are command acknoledgement, the icon corresponding to the command is
displayed to confirm reception of the command.
Status confirmations : These confirmations are displayed when the status of a zone, monitored by the system, changes.
e.i. : door openning, security system alarm state, etc.
Command confirmations are returned immediatly following a command transmission whereas the status confirmations may
be returned up to 12 seconds after the event appened depending on the communication protocol between the hand-held unit
and the vehicle.
Remarks: When the remote receives a confirmation that is intended to a vehicle other that the one actually selected, most
audible confirmations are made more descret, vehicle icon flashes (1-4) to warn you that the display reflect the status of that
specific vehicle.
When a command is transmitted, the vehicle selection gets back to the previously selected unless the confirmation was
related to an alarm condition.
In that case the selected vehicle is temporarely changed, to allow stopping the alarm condition without having to change the
vehicle selection, then gets back to previously selected when the alarm condition is stopped.
Out of range : In the event that the environement prevents the confirmation from being received by the remote control, all
icons are cleared out. In this case, resend the command or send the status command to refresh the display.