Filter
Top Products
Support Bracket into the center adapter and position it on either side of the
TransDock Direct Cradle.
5. Insert the included stereo mini cable into the Aux-In Jack on the bottom of
the TransDock Direct Cradle and connect to your car stereo’s auxiliary input.
The car’s aux-in port may be located on the dashboard, alongside the stereo,
under the dash or even in the glove compartment. Consult your car’s
owner’s manual for details.
6. Click Play on your iPod to enjoy your music over your car stereo.
7. To control the overall volume of your music while using your TransDock Di-
rect, use the stereo’s volume control, not the iPod volume. The volume con-
trol function on your iPod is disabled while docked.
NOTE: To power another device, connect the detachable 12V Power Socket to
the 5.5mm port on the top of the Car Power Adapter. You may now simultane-
ously power another device while enjoying your iPod. See Using Your Detach-
able 12V Power Socket on page 10 for more information.
IMPORTANT: Do not insert anything other than an appropriate plug that fits the
socket, or allow any liquid to get into the socket. Doing so may cause electrical
failure, electric shock, or a short circuit. The total combined current for the 12V
socket should not exceed 10 amps. This accessory outlet should be used for ac-
cessories only; do not use a lighter element in this outlet.
|9
Using TransDock Direct
Detailed Instructions
1. Turn on your car stereo and set it to AUX mode.
NOTE: Labeling may vary by vehicle. Consult your car’s owner’s manual
for details.
2. Assemble your TransDock Direct by attaching the Flex Arm to both the Car
Power Adapter and the TransDock Direct Cradle.
NOTE: For cars that do not need the additional length of the Flex Arm, you
may attach the TransDock Direct Cradle directly to the Car Power Adapter.
3. Insert your TransDock Direct into your auto power outlet. TransDock Direct
will indicate that it is receiving power with a single illuminated light on the
front of the cradle.
4. Gently slide your iPod onto your TransDock Direct. Your iPod will now begin
charging if your car is on. The TransDock Direct display shows power status
at a glance – one light when connected, two when iPod is charging, and three
when iPod is fully charged.
NOTE: To ensure the best fit for your particular iPod, press the button on
the upper right side of the TransDock Direct Cradle to extend or contract the
circular adapter in the center of the TransDock Direct Cradle. Release the
button to lock the adapter’s position. For iPod touch users, you may attach
the included iPod touch Support Bracket, which allows you to position your
iPod touch horizontally in the TransDock Direct Cradle. Insert the iPod touch
8 | DLOTRANSDOCKDIRECTUSER MANUAL