Filter
Top Products
6. Install nut strip into end of frame and
secure with two 1/2" x 1-1/2" hex
bolts, flatwasher and lockwashers on
each side.
7. Cut lower valance panel, as shown above, and reinstall. Replace license plate bracket using two
1/4" x 3/4" hex bolts, flatwashers, lockwashers and hex nuts.
TOP
1-1/2" wide x 2-1/4" tall
5/8" from top edge
5-3/16"
7. From valance center support measure over 12-1/8 and make a
vertical line. From valance opening wrap tape measure around
curve of valance measuring 3-1/2, make a horizontal line there.
Where the two lines intersect drill using a 2-1/2 hole saw. repeat
for the other side. Note: minor cutting or trimming may be
required for proper fit.
1999 Ford F-150/Expedition (2wd) Valance Cutting Instructions
1997-1998 Ford F-150/Expedition (2wd) Valance Cutting Instructions
See below for proper valance cutting
instructions. When finished reinstall
valance and license plate bracket.