Filter
Top Products
2. Install baseplate to frame with 1/2" x
5" hex bolt, two flatwashers,
lockwasher and hex nut, on each side,
in rear hole of baseplate. Bolt goes
from inside of frame outwards with
rear brace plate on outside of frame.
On passenger side use lower slotted
hole and drivers side use upper slot-
ted hole.
Secure brace plate to base plate us-
ing two 3/8" x 1-1/4" hex bolts,
lockwashers and hex nuts on each
side.
PASSENGER SIDE
DRIVER SIDE
3. Secure front of baseplate by placing
heavy frame washer over 1/2" x 5" hex
bolt and insert into frame from outside
of frame inwards with spacer tube
inside frame, there are extra 1/2"
flatwashers included to shim this tube
tight against inside walls of frame.
Secure with 1/2" flatwasher,
lockwasher and hex nut.
5. Drill two 1/2" holes thru frame, on
each side, using base plate as a tem-
plate.
4. Position base plate so front angle cut
is approx. even with front of frame.
Push base plate up and tighten 1/2" x
5" hex bolts.