Filter
Top Products
4 MAN#650334:A
FUNCTION SWITCH
The push button function switch mounted beside the speedometer allows access to all of the mileage and
performance information. Pressing and releasing the function switch toggles through the different displays. Pressing
and holding the switch for about 2 seconds will reset the current display. The display sequence is as follows:
SPEED MENU
000000 odometer mileage
A
000.0 trip meter mileage A
B
000.0 trip meter mileage B
S 0000 count down to service (if programmed)
++++++ Speedometer will show km/h (or MPH if metric)
PERFORMANCE MENU
HI 00 high speed recall
60 00.0 0-60mph time (0-100kph)
25 00.0 quarter mile time
25 00 quarter mile speed
The 0-60 and ¼ mile timers are zeroed by pressing and holding the switch while that timer is displayed. The timer will not
restart until the speed reaches zero and you start driving again.
GAUGE SETUP AND CALIBRATION
The function switch, discussed above, is used to enter setup mode for all of the gauges. If you are only
installing one or a couple Dakota Digital MCL-3K gauges, setup may seem a little strange since they are designed to
work as a set. The first step in the setup procedure is to select which gauge you are going to adjust. Each gauge will
either show a number or a label. If the gauge is showing a label then that gauge will be selected to enter setup. All of
the other gauges will exit setup and allow the selected gauge to be changed. To get into setup, press and hold the
function switch while turning the key on. Press and release the switch to advance through the menus below, when on
the desired option, press and hold the switch to select setup for that particular gauge/function.
speed tach oil psi oil temp fuel volt
1
st
- 1 - CL - 1 - - 1 - - 1 - - 1 -
2
nd
SPd - 2 - - 2 - - 2 - - 2 - - 2 -
3
rd
- 3 - tCH - 3 - - 3 - - 3 - - 3 -
4
th
- 4 - - 4 - PSI - 4 - - 4 - - 4 -
5
th
- 5 - - 5 - - 5 - F or C - 5 - - 5 -
6
th
- 6 - - 6 - - 6 - - 6 - FUL - 6 -
7
th
- 7 - - 7 - - 7 - - 7 - - 7 - uLt
8
th
- 8 - - 8 - - 8 - - 8 - - 8 - - 8 -
FACTORY DEFAULT SETTINGS FOR SETUP MENUS
Below is a list of all of the factory gauge settings and what can be adjusted in the setup menus. You can
calibrate and adjust the speedometer as often as you wish, however they should only need to be set once. The
speedometer calibration will need to be performed to match the gauge for your bike.
Speedometer
Unit MPH
Service Meter OFF
Performance Menu ON