Filter
Top Products
2 MAN#650334:A
ROAD GLIDE FLTR
You will need to remove the speedometer and tachometer instrument bezel. To do this, remove two small
screws on the left and right side of the bezel. Then lift up on the back of the bezel and slide the tab that is under the
ignition switch out from under the switch cover, see photos below of ignition switch cover removed to show detail. Now
unplug the gauge connections (cable where applicable). Remove switch, and unplug the idiot lights so the bezel can be
completely removed for easier installation of the new gauges. Remove the clamp(s) that hold the gauges to the bezel
and remove the gauges and grommets/gaskets.
Picture of tab (switch cover removed) Bezel removed Gauges/Grommets removed
Install New Gauge
Note: This step is only for those with out a factory switch or cable drive applications since the switch
was mechanical and attached to the speedometer. Now is a good time to install the function switch for cable drive
applications, it can be hard to mount once the gauges are installed. Remove the rubber boot, insert the switch from the
back of the fairing and then tighten the rubber boot on from the front.
Next you are ready to install the new gauges into the fairing. The new speedometer comes supplied with a
new gasket and clamp. Install the gauge and secure using the supplied clamp and gasket. Be sure the alignment tab
on the clamp lines up with the notches in the fairing. Some fairings may only have one notch, line up at least one tab
on the clamp with the notch in the fairing, this will insure the gauge is centered and aligned correctly.
Speedometer