Filter
Top Products
MAN# 650304:F
• Remove the dash
• Unclip and unplug the factory gauge
• Remove the rubber gasket from the factory gauge bezel
• Install gasket over the bezel of the Dakota Digital gauge.
The gasket doesn’t cover the entire bezel, there should
be some chrome showing when the gasket is installed
• Screw the ABS mounting bracket to the back of the
gauge with the two 8-32 screws and lock washers.
The smooth side of the ABS should go down towards
the back of the can this will align the gauge properly
in the dash.
• Snap the gauge into the dash starting with one tab in and then working in
a clockwise direction snapping the other two tabs in one at a time. The
tabs are tight so it takes a fair amount of pressure to snap them in make
sure they are seated under the tabs in the dash once locked in
• Plug in the connector and reinstall the dash.