Daewoo DOORS Automobile Parts User Manual


 
DOORS 9P 21
DAEWOO M-150 BL2
D19C608A
Installation Procedure
Notice: Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use the correct
fastener to prevent premature corrosion.
1. Connect the bodytodoor rubber grommet.
2. With the aid of another technician, lightly secure the
front door with the bolts.
3. Adjust the door for proper fit.
4. Tighten the hingetobody bolts.
5. Install the door hold open link with the bolt.
6. Install the fender. Refer to Section 9R, Body Front
End.
7. Connect the electrical connector.
8. Connect the negative battery cable.
9. Perform the waterleak test. Refer to Section 9I, Wa-
terleak.
10. Check for windnoise. Refer to Section 9J, Wind-
noise.
D109C609
REAR DOOR ASSEMBLY
Removal Procedure
1. Disconnect the negative battery cable.
2. Pry off the lower Bpillar trim panel. Refer to Section
9G, Interior Trim.
3. Disconnect the rear door electrical connector.
a. Rear door electrical connector.
D109C610
4. Remove the rear door assembly.
D Remove the door hinge bolts (1).
D Remove the door hold open link bolt (2).
D Disconnect the bodytodoor rubber grommet (3).
D Remove the rear door assembly (4).