Daewoo 450/450Plus Automobile Parts User Manual


 
Diesel Engine Complete Engine
65
Install the other snap ring into the snap ring groove.
NOTE: Make sure the connecting rod moves freely
forward and backward after installing the
last snap ring.
Locate the end gaps of the piston rings as shown.
1. Top Ring
2. Second Ring
3. Oil Ring
4. Part Number Mark - “EXXXX”
- XXXX = Last Four Digits of the Part Number
- “NA” or “T”
- NA = Naturally Aspirated
- T = Turbocharged
NOTE: Align the notch of the upper bearing with the
notch of the connecting rod.
Install the upper connecting rod bearing into the
connecting rod.
NOTE: Coat the inside face of the cylinder, the
piston rings, and the surface of the
connecting rod bearing with engine oil (SAE
30). Install the piston and connecting rod
assembly with the “F” mark on the piston
facing the front of the engine.
NOTE: The connecting rods are stamped with the
number of the cylinder in which they are to
be installed. This match mark must be on
the camshaft side of the engine after
installation.
Set the crankshaft pin to bottom dead center.
Install the piston and connecting rod assembly from
the top of the cylinder block using piston holder, Part
No. 3397773.
00900196
00900225
00900226
00900228