Filter
Top Products
-
---
MESSAGE DISPLAY FOR STANDARD TRUCK
If your truck slows down or won't work, check the message display for instructions.
Display Panel Messages
AUDIO ALARM
Anytime you hear a "beep", something is wrong. Check the message display.
17 Display Panel Messages
Optional Expanded
Message display
Standard
Message Display
Load is too heavy for the lift zone you
are operating in.
Check that the alarm, message display
and all lights are working.
TEST
Both feet must be on the correct pedals/pad.
FOOT
Return the multi-task control handle to
neutral.
HAND
Make sure battery retainer is in place
and secure.
DOOR
Remove your foot from the entry bar.
ENT
What To Do
RCUT
Forks are at cutout height. Use the cutout
override switch to continue raising.
ADDITIONAL MESSAGES FOR CAPACITY DATA MONITOR OPTION
If your truck has this option, the following messages can also be displayed.
Make sure the forks are not tilted all the
way up or down. If the problem continues,
notify your service department or supervisor.
CTR
During start-up, briefly move left foot
to the Center Brake Pedal.
Enter your user code (PIN number).
LAMP TEST
LEFT OR RIGHT PEDAL
CENTER HANDLE
ENTRY BAR
BATTERY DOOR
USER CODE: / - - -
RAISE CUTOUT
CENTER PEDAL
CHECK LOAD
MONITOR DISABLED
Switch Panel 18
Switch Panel
RAISE CUTOUT OVERRIDE SWITCH (optional)
Your truck may be equipped with automatic cutout of raise
at selected lift heights.
To raise past the cutout height, push the optional Raise
Cutout Override switch while, at the same time, lifting the
multi-task control handle (see page 29).
Caution: Make certain the load and load backrest will
clear all overhead obstructions.
DOME LIGHT SWITCH
FAN SWITCH (optional)
WORK LIGHT SWITCH (optional)