Filter
Top Products
Move control handle to
brake position to stop truck.
Truck will coast
if handle stays in drive
position when released.
Coast Controls optional
19 Coast Controls optional
COAST ON
Move the control handle to the coast position and shift
the coast selector lever toward the control arm.
With coast on, the truck will coast when you let go of
the control handle. You must move the handle to a brake
position to apply the brake.
COAST OFF
Move the control handle down and shift the coast selector
away from the control arm.
When coast is disabled, braking will return to standard
operation (see page 15).
COAST, A WALKALONG CONTROL OPTION
You can use one of two optional coast controls to make
it easier to pick loads while walking short distances with
the truck. This feature allows the truck to coast when
you let go of the control handle. However you can apply
the brake by moving the control handle to one of the
brake positions.
Be even more careful when using coast. Make sure you
understand the possible hazards. Don't place yourself
or others at risk.
High travel speed is not available while coast is engaged.
OPTION 1, MANUAL COAST SELECTOR
Brake
On
Brake On
Coast
Brake
On
Brake On
Coast
Coast Controls optional 20
Continued next page...
OPTION 2, ELECTRONIC QuickCoast
TM
SELECTOR
COAST ON
Move the control handle to the coast position and press
the coast selector button on the back of the grab bar,
opposite the raise/lower switches. The “no-brake” symbol
at the base of the control handle will light and a single
“beep” will sound to warn that the truck is in the coast
mode.
With coast on, the truck will coast when you let go of
the control handle. You must move the handle to a brake
position to apply the brake. A “beep” will continue to
sound as long as the handle is in the brake position.
COAST OFF
To turn coast off, either press the high travel speed button
on the grab bar, turn the key switch to OFF, or disconnect
the battery. The “no-brake” symbol will go out, and the
control handle will return to vertical.
If you accidentally hit the reversing button when the
handle is in the coast position, coast is also disabled.
When coast is disabled, braking will return to standard
operation (see page 15).