Filter
Top Products
WIRING:
1. Choose a convenient place to run the cable either down the left side or right side A-Pillar of the
vehicle. (The left side is usually the easier side)
2. Remove the trim panel from the A-Pillar and route the cable down the pillar to the dash board.
3. In most vehicles, there will be a wire harness for the dome light inside the A-Pillar of the vehicle.
Use a wire tie or electrical tape to secure the cable to this wire harness.
4. Re-Install the trim panel. Make sure that the cable does not interfere with the mounting clips or
screws of the trim panel. This may cause damage to the cable and the trim panel and may cause
the trim panel to not fit back into position properly.
5. Connect the RED wire to a +12V or +24V DC Ignition power terminal which is energized when the
key is turned to the Ignition or “On” position.
6. Connect the GREEN trigger wire to the +12V or +24V Reverse Light wire.
7. Connect the BLACK wire to a suitable Ground on the vehicle.
8. Connect the Grey (V1) connector to the video output of the reverse camera. V1 is the priority
input and will always auto switch when the vehicle is shifted into reverse.
9. Connect the Grey (V2) connector to the video output of any external video device (DVD, VCR,
etc)
VEHICLE REVERSE LIGHT
REVERSE CAMERA
SV-9155 MIRROR
CAM 2
V2 Normal Image Input
Connect to External Video Source
V1 Reverse Image Input
Connect to Reverse
Camera
YELLOW
RCA Video Output
Camera
Power Plug
Audio Inputs (NOT USED)
CAM 1
10' LENGTH
CABLE
BLACK
Chassis Ground
RED
+12V Switched IGN On
GREEN
+12V Reverse
Light
VIDEO ADAPTER PLUG
VEHICLE IGNITION
NOTE
• Before making any power connections to the vehicle, disconnect the Ground terminal of the
vehicle battery to avoid any short circuits
• All plugs should be fully inserted into the connectors and secured tightly with electrical tape to
assure the best connection. A loose connection may cause malfunctioning of the unit