Filter
Top Products
CONVENIENCE AND SAFETY FEATURES
EZ-30 ONLY: KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional)
This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote
control for safety and convenience. Note: This feature may require extra labor and/or parts to install. Press the
Lock or Unlock transmitter button as you leave or come near the vehicle. Parking lights will flash once for lock and
twice for unlock. If vehicle is running by the remote start system, the lights will flash, but return back to solid.
EZ-30 ONLY: AUTO LOCK/UNLOCK
The Auto Lock feature controls whether the doors will automatically lock/unlock on your vehicle when driving or
with turning the Ignition ON/OFF. If the Auto Lock feature is turned on, and your system is in “Tach” mode, then
the doors should automatically lock as the engine RPM’s increase (driving). If the Auto Lock feature is turned on,
and your system is in “Smart Tachless” mode, then the doors will lock a few seconds after the Ignition is turned on.
When the Auto Lock feature is turned on, the system will always unlock the doors when the Ignition is turned off.
With this feature turned OFF, the system will not automatically lock or unlock the vehicle. See your installer for
programming information on this feature.
EZ-30 ONLY: CAR FINDER ASSIST
To assist in locating your vehicle in a parking lot or structure at night, press the Lock Button on the remote for
more than 2 seconds. The vehicle will flash the parking lights for 1 minute. Reset by pressing the lock/unlock
button.
VALET MODE (Program button required)
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The
remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position, press
and hold Program/Valet Button for 5-6 seconds. The LED will turn on solid and the system is now in valet. Perform this
procedure again to exit of Valet mode. The keyless entry will still function normally while in valet mode. In the event of a
lost or broken transmitter, perform this step to override the Starter Disable (if installed).
ANTI-GRIND (Optional, relay not included)
This Optional feature prevents the user from accidentally grinding the starter if the Ignition key is turned too far to the start
position while engine is already running from the remote starter. The Anti-Grind requires an external relay.
HOOD OPEN SAFETY (Requires grounding hood pin installation)
This feature prevents the engine from being remote started when hood is open. Helps eliminates risk of injury to someone
working under the hood of the vehicle with a properly working hood pin installed. If Remote Start button is pressed with the
hood open, the unit will not attempt a start.
8