Filter
Top Products
OPTION PROGRAMMING
To change programmable options:
1. Turn the Ignition ON, wait one second, and press the Override/Program button 5 times.
2. The system should flash the parking lights 8 times in quick succession.
3. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the options chart below. Parking lights and/or optional LED should flash for each button press. Don’t lose count!
4. When you get to the desired option number, press the appropriate button on the remote according to the chart
below. Turn Ignition off. (See Below for Option numbers, descriptions, and values.)
5. Change one option at a time repeating these same steps. When you are finished customizing options, check
operation to see if the option(s) have changed.
PROGRAMMING OPTIONS CHART * = DEFAULT SETTING
Option #
Option Description Selection Lock Button Unlock Button
1. Auto Lock & Unlock with Ignition ON or OFF ON* OFF
2. Double Unlock Pulse ON or OFF OFF* ON
3. Horn Chirp ON or OFF ON* OFF
4. Lock/Unlock Pulse Time 0.8 Sec. or 3 Sec. 0.8 Sec.* 3 Sec.
5. Passive Starter Disable ON or OFF OFF* ON
6. Ignition Trigger ON or OFF OFF* ON
1. AUTOLOCK / UNLOCK WITH IGNITION
Controls whether the doors will automatically lock when the ignition is turned on and will unlock when the ignition is
turned off. Note: When Separate Driver’s Door Unlock feature is installed, only driver’s door will unlock when
IGN. is turned off.
2. DOUBLE UNLOCK PULSE
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing
this system into specific Nissan, VW, Toyota, and Lexus vehicles that require 2 unlock pulses to unlock the vehicle.
3. HORN CHIRP CONFIRMATION
This option turns the horn chirps for lock/unlock on or off.
4. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.8 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required for
1980’/90’s European Vehicles that require a long pulse to operate electric vacuum type door lock systems.
5. PASSIVE STARTER DISABLE OUTPUT (Applies to OPTIONAL starter disable feature)
This option modifies the unit’s (-) Negative Armed Starter Disable output operation. When this option is turned ON, the
unit will PASSIVELY activate the Starter Disable 45 seconds after the ignition is turned off. Starter disable output is
deactivated through the remote when unlocking the vehicle or a manual override.