Filter
Top Products
#2 DISARM
UNLOCK
LCD
SCREEN
#4 ENGINE
START/STOP
#1 ARM
LOCK
#3 TRUNK
#5 RECALL
CAR I or II
FIXED
ANTENNA
AM
BUTTON 5
(On side of remote):
• Press and release to light up
the LCD screen.
• Press and release twice to
recall the last message from
the LCD screen.
• Press and Hold two seconds
to change from Car 1 to Car 2
• Press 5 times to change the
Time and audible beep tones
on the remote.
TRANSCEIVER / PAGER-REMOTE
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and
receive information from the vehicle. The Control Module
transmits High Frequency AM/FM signals from the vehicle
to your over long distances. Your range will vary depending
on location, terrain, and local RF noise/interference. This
system is not guaranteed to page you if you are behind
concrete walls, underground, in a large structure, or in an
area with high levels of electronic interference. Handle the
pager/remote with care if the LCD display and/or the
electronics may be damaged if subjected to abuse. The
AAA Cell 1.5V alkaline battery can easily be replaced by
sliding open the battery access door on the back of the
remote. Battery life will vary depending on usage. The
LCD screen will display a low battery icon when the battery
is low. For more see “Range Questions” on page 17.
BUTTON 1(Lock Symbol):
• Press and release to Arm/Lock system.
• Press and Hold for more than 3 seconds to activate “Panic” feature.
BUTTON 2 (Unlock Symbol):
• Press and release to Disarm/Unlock system, or reset a cycle.
BUTTON 3 (Trunk Symbol):
• Press and Release to activate trunk pop (Auxiliary output #1) Optional
Feature.
• Press and Hold to activate a second optional feature (Auxiliary output
#2).
BUTTON 4 (Start Key Symbol):
• Press and release to Start/Stop engine.
3