Filter
Top Products
LED DIAGNOSTICS
The CS-2014FM system includes disarm diagnostics, through the RED LED light, that will help in determining
what caused the last trigger of the alarm system. This is a valuable tool in determining how the vehicle was
tampered with or if there is a false alarm problem in which case you can make the necessary adjustments to
correct the problem. When the system is disarmed with the remote you will hear the normal 2 chirps, then 4
quick chirps that indicate the alarm was triggered while you were away. Check the LED light for a sequence
of flashes:
Shock Sensor = 1 Flash Door = 2 Flashes Hood/Trunk = 3 Flashes Ignition = 4 Flashes
Diagnostics will reset when the Ignition is turned on or when the system is re-armed.
TRANSCEIVER / REMOTE CONTROL PROGRAMMING
Note: All transmitter codes must be Code Learned at time of programming! Up to 4 different
transmitter codes can be stored in the memory of the system. One remote cannot be programmed
multiple times.
1. Open Hood (Ground the Blue wire if no hood pin is installed.)
2. Turn key to the ON position.
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. Press buttons #1 (Lock) & #2 (Unlock) together at the same time of each transceiver to be learned. You
should get 2 light flashes indication the unit is waiting for a 2
nd
code, then press button #1 & #2 of a second
transmitter or transceiver, the unit will flash 3 times indicating its waiting for the 3
rd
code and lights will flash
4 times for 4
th
code. If all 4 codes are learned, the unit will automatically exit code learning mode,
otherwise turn key off and close hood.
NOTE: When Code Learning 2-Way Remotes, wait for the LCD to confirm with a beep and the antenna
ICON on the LCD screen BEFORE learning the next remote.
SEE DIAGRAM ON NEXT PAGE
14