Crimestopper Security Products CS-2011RS Automobile Alarm User Manual


 
#3
#1
CS2011RS TRANSMITTER
#2
#4
START
LOCK/
AUX 1,2
ENGINE
START/STOP
UNLOCK/
C
RIME
S
TOPPER
ARM
DISARM
OPERATION CAUTIONS & WARNINGS
CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from
the use of this equipment. This system is designed to be professionally installed into a car or vehicle in goo running
order. Items, such as parking brake, door switches, and all engine safety features, must be in perfect working
condition.
IT IS ABSOLUTELY THE OWNER’S SOLE RESPONSIBILITY TO: A) Understand the operation of this
system and its safety features. B) Check for proper operation of these safety features prior to accepting
delivery of the vehicle from the installation facility. C) Check and maintain the condition of the vehicle and all
items relative to the proper operation of this system and its safety features.
DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is
adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon
Monoxide fumes. This is especially important when using the Time Self-Start feature of the unit
OPERATING INSTRUCTIONS
Active Arming / Locking:
Press button #1 (Lock symbol) on the transmitter. System will arm and
confirm with one siren chirp, one light flash, and the LED begins to flash
slowly. Power locks will lock (if equipped). Starter disable circuit is
enabled
Disarming: / Unlocking
Press button #2 (Unlock symbol) on the transmitter. System will disarm
and confirm with two siren chirps, two light flashes, and LED will turn
off. Power locks will Unlock and Interior Dome light will turn on (if
installed with these optional features)
Disarming While Tripped (Triggered):
Disarming the System when it is triggered requires two presses of the #2 Unlock Button. The first press of
Button #2 Resets the alarm cycle only (system still armed) while a second press will disarm/unlock the system.
Silent Arming/Disarming:
To Arm or Disarm the system without siren chirps, press and release both Buttons #2 (Unlock) and #4 (Start)
at the same time. System will Arm or Disarm without siren chirps. Flashing lights and LED will be the only
indicators of Arm/Disarm status. If the system was tripped while you were way, 4 chirps will be heard to notify
you that the system was tripped.